Safety Instructions - cecotec Conga WinDroid 870 Connected Manual De Instrucciones

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
Make sure that the mains voltage matches the voltage stated
on the rating label of the appliance and that the outlet is
grounded.
This appliance is intended for home use only.
It is not suitable for commercial or industrial use.
Check the power cord regularly for visible damage. If the cord is
damaged, it must be replaced by the official Technical Support
Service of Cecotec, in order to avoid any type of danger.
This product can only be disassembled by qualified personnel.
Do not touch wires, power supplies or power adapters with
wet hands.
Keep the robot away from clothing, curtains and any other
similar materials. Keep hair, clothes, fingers and other body
parts away from openings and moving parts of the robot.
Do not sit or place heavy or sharp objects on top of the appliance
nor its cable.
Do not place the appliance close to heat sources, flammable
or wet substances, where it can fall or be pushed into water or
allow it to come into contact with water or other liquids.
Do not use the charging base if it has a damaged cord or plug
or if it is not operating properly. Contact the official Technical
Support Service of Cecotec.
The appliance can only be operated with the supplied battery
and power adapter. The use of other components or accessories
could cause risk of fire, electric shock or product damage.
Do not expose the device to excess humidity or to rain, and
keep it away from liquids.
Do not expose the device to direct sunlight, intense light or
strong magnetic fields.
The optimum product operating temperature is 0 ºC-40 ºC.
Allow adequate ventilation around the adapter when using it
to operate the device. Do not cover the power adapter with
objects that could reduce the device cooling process.
To avoid hazardous situations, do not disassemble, short-
circuit, burn or heat the battery above 60 ºC.
Make sure the robot is disconnected from the power plug and
switched off before cleaning or repairing it. Pull from the plug,
not the cord, to disconnect it from the outlet.
Do not twist, bend, strain, or damage the power cord in any way.
Do not damage, bend or twist the power cord. Do not place any
heavy or sharpened objects on the cord, this could cause a fire
or electrical shock.
Do not insert pointed objects into the electric contacts.
Do not use the robot on frameless glass.
Do not use the product on cracked glass. Reflective or coating
glass might be slightly scratched due to dirt on the glass while
operating.
The appliance is not intended to be used by children under the
age of 8. It can be used by children over the age of 8, as long as
they are given continuous supervision.
This appliance is not intended to be used by persons with
reduced physical, sensory, or mental capabilities, or lack
of experience or knowledge, unless they have been given
supervision or instruction concerning the use of the appliance
in a safe way by a person responsible for their safety, and
understand the hazards involved.
Supervise young children to make sure that they do not play
with the appliance. Close supervision is necessary when the
appliance is being used by or near children.
It is not suggested to use it on glasses thicker than 3 mm.