Publicidad
Idiomas disponibles
Idiomas disponibles
The Cycle Completion
Signal
This Cycle Completion
Signal
is a tone that sounds
to alert you when
your dishwasher
finishes
washing
and drying
your dishes. You can either
disable
the tone
or set the volume.
To activate:
• Press and hold the right "Cancel
Drain"
button
then
press and hold the On/Off
button.
• When the light on the "Cancel
Drain"
button
you are pressing
illuminates
and the tone
begins
to sound,
release
both buttons.
• Press the right-most
"Cancel
Drain" button
until the tone
is either
at the desired vol-
ume or is silent.
• Press the On/Off
Button.
The Cycle Completion
Signal is now set.
Hygiene
Dry Low Rinse Agent
Compensator
(Models
DWHD64C,
DWHD64E)
This feature
senses when the unit is low on rinse agent
and automatically
increases
the
drying
time.
For best performance,
always
use a liquid
rinse agent
even if your detergent
contains
a drying
additive.
Starting
the Dishwasher
To start the dishwasher,
follow
the instructions
in Table 2.
PowerBeam
Status
Indicator
(Models
DWHD64C,
DWHD64E)
Red LED illuminates
the floor to indicate
the unit is running.
When the cycle is complete
the
light will go out.
Table
2
_-_ __!!!!!i!!!i!!!i!!!!!!!!!i!!!i!!!i!!!!!!!!!i!!!i!!!i!!!!!!!!!i!
i _ii_1
,e
i
4. Close the door to
start.
Interrupting
a Cycle
NOTE: Should you need to interrupt
a cycle (to add or remove
an item,
to add detergent,
etc.),
it is best to do so within
the first 30 minutes
of the cycle.
,WARNING
You could
be seriously
scalded
if you allow
hot water
to splash
out of the dishwasher.
OPEN THE DOOR CAREFULLY
during
any wash
or rinse
cycle.
Do not fully
open
the
door
until
water
noises
have stopped.
Hidden
Top Controls
1.
Open the dishwasher
door just far enough
to expose
the control
panel.
2.
Press the ON/Off
button
to turn the unit off.
3.
Wait at least ten seconds
or until the water
noises stop before opening
the
dishwasher
door.
4. To resume
the cycle, press the On/Off
button
and close the dishwasher
door.
Canceling
or Changing
a Cycle
To cancel
or change
a cycle, press and hold for three
seconds the two butons
labeled
"Cancel
Drain" as shown
in Table 3.
Wait approximately
one minute,
then
press the On/Off
button.
You may now begin a new
cycle.
Dishware
Drying
At the end of the cycle the dishwasher
will stop and a period
of condensation
drying
will
follow.
After drying,
the cycle is complete
and:
• the "Clean" light will illuminate
(Models
DWHD64C,
DWHD64E).
• the completion
signal will sound.
• the "Sanitized"
light may appear.
See section
on Sanitization
for more information.
• the PowerBeam
light will go out (Models
DWHD64C,
DWHD64E).
• the countdown
display
will show "0" (DWHD64C
only).
NOTE: To accelerate
and enhance
drying,
open the dishwasher
door, pull the top rack a
Table
3
000
• iCancel
Drain m
•
13
Publicidad
