Installing Mobile Mic Gateway To A Mobile Radio; Mounting The Hang-Up Clip; Making Final Connections - Motorola PMMN4095 Guia Del Usuario

Installing Mobile Mic Gateway to a Mobile
Radio
Carefully select the installation location for the Mobile Mic Gateway.
Plan the installation so that the Mobile Mic Gateway's location is within
convenient reach of the user, but will not interfere with the vehicle's
operation. Also, consider the operation of other vehicle accessories.
Functions assigned to the hook switch on the Mobile Radio are not
supported with the Long Ranges Wireless Solution. Therefore, the hook
switch functions must be set to disabled on the Mobile Radio.

Mounting the Hang-Up Clip

Once an installation location has been decided, perform the following
steps:
Procedure:
1
Verify that the selected mounting surface is strong enough to
support the mounting hardware and the Mobile Mic Gateway.
2
Use the base of the hang-up clip as a template to center punch and
drill two three millimeter (0.125 inch) diameter holes. Be careful not
to damage any wires or any other vehicle components when drilling
the holes.
3
Use the two self tapping screws provided to mount and secure the
hang-up clip.
16
English
1
Back-up Plate
Figure 3.1: Installing the Mounting Bracket

Making Final Connections

When the hang-up clip is installed and secured, follow the steps below:
Procedure:
1
Snap the Mobile Mic Gateway into the hang-up clip.
2
Connect the Mobile Mic Gateway's coiled cord plug to the Mobile
Mic Gateway's connector on the front of the radio. Align the
connector pins then twist outer collar clockwise to lock in place.
Vehicle
2
Dashboard
Hang-up
3
Clip
Flat-Head
4
Screw
Hex-Washer
5
Head Screw