Adjusting The Head Band - SATA vision 2000 Instrucciones De Servicio

Notice!
The service life of the activated charcoal absorber in the belt unit
[1-7] and the quality of the breathing air is extensively determined by
the pre-cleaning of the admitted compressed air. The SATA filter 444
(# 92296) with automatic condensate drain must therefore be installed
upline of the activated charcoal absorber. It filters practically all water
and dust particles out of the admitted compressed air. If the pressure
difference between pressure gauges [5-1] and [5-2] is greater than
1 bar, the fine filter cartridge has to be replaced (change at least every
six months; see operating instructions for SATA filter 400).
Variant 2 and 3
Notice!
The SATA filter 464 activated charcoal filter (# 92247) [4] must be
installed upline of the breathing protection hood to remove oil mist
vapours from the breathing air. The activated charcoal filter must be
checked for proper function at regular intervals and serviced, when
necessary. In order to avoid saturation of the activated charcoal filter
cartridge, it has to be replaced every 3 months.
The time indicator is included in the scope of supply of every filter and
replacement cartridge!

8.2. Adjusting the head band

For individual adjustment to the wearer's head, the head band has two
setting possibilities.
■ To adjust the head band, open the hook-and-loop tape on the head/
breast cloth.
■ Fold the head/breast cloth forwards over the spherical cup.
1. Adjusting the head band to the head circumference
■ Release the lock by turning the outer knurled ring on the ratchet com-
pletely to the left.
■ Use the adjusting screw on the ratchet to increase or decrease the
circumference of the head band until it fits the head without pressure.
■ Fix the adjustment by turning the outer knurled ring on the ratchet com-
pletely to the right.
2. Adjusting the height of the head band
The lower edge of the front head band should be approx. 1 cm above
Operating Instructions SATA vision 2000
EN
143