Port Settings - Cameo XNODE 4 Manual De Usuario

PORT SETTINGS

For each port, there is a settings menu under Home > Menu > Ports > Port [1-4]. E.g. the menu for port 1 is under Home > Menu > Ports
> Port 1. The port settings menu contains the items described below. When opening this screen with a double tap to the port button (button
[1] – button [4],) this menu is shown as a reduced version with only the options required for configuring the current mode.
UNIVERSE
To adjust the universe of port X, navigate to Home > Menu > Ports > Port X > Universe. This screen can also be reached by pressing the
corresponding port button once.
This screen provides essential information about the DMX port and allows for changing its Art-Net or sACN universe. For more information
about the indicators on this screen, see section Port Screen.
Use the encoder wheel for changing the universe of the given port. Once the desired universe appears on the screen, push OK to use this
universe or press cancel to revert to the previously configured universe.
ART-NET (VERSION 4)
This section describes the universe configuration screen of ports that are in Art-Net mode while the Art-Net version is set to Art-Net 4.
The port address is the large number on the bottom of the display. While it is being edited, a slowly blinking cursor is shown below the cur-
rently editable digit. Use the encoder to increase or decrease that digit. Push the port button corresponding to the port that is being edited to
change the digit that is currently editable. Firmware versions 1.01 and later also display the Art-Net net, the Art-Net sub-net and the Art-Net
universe part of the port address on the lower half of the display near the left edge.
If an input port is configured for Art-Net 4, data is transmitted to the directed broadcast IP address (e.g. 2.255.255.255).
For more information about the addressing of Art-Net ports, see section Representations of Art-Net Port Addresses in the appendix.
ART-NET (VERSION 3)
This section describes the screen for editing the universe of a port running in Art-Net mode when the Art-Net version is set to Art-Net 3.
The screen looks the same on devices with a firmware older than version 1.01 if the corresponding port is in Art-Net mode and independent
universes are disabled.
Please note that while the universe (large number on the right-hand side of the display) is being edited but has not yet been stored, its
background lights up and the number is displayed in its inverted colour about once every second. If that is the case and you just want to see
the configured universe number, simply press [Cancel].
14