Replacing The Dust Bag - Nilfisk GM 100 Sprint Plus Instrucciones De Uso

DJ68-00085W(EN) 10/4/04 12:59 PM

REPLACING THE DUST BAG

1. To open the dust cover of the dust
bag compartment, press the
clamper upward.
(The clamper is located at the front
of the dust cover)
3. After removing the used dust bag,
insert the cardboard bag collar of the
new dust bag into the carrying bag,
and then insert it in its original position
NOTE: Used dust bag can be sealed
by removing the film from the
paper and sticking the latter
over the suction opening.
MAINTENANCE OR REPLACEMENT OF THE FILTERS
1. INLET-FILTER.
• Open the dust cover.
• After detaching the filter, wash it lightly with
water, dry it in the shade, and then insert it in
its original position.
• Close the dust cover.
2. OUTLET-FILTER.
• Open the dust cover, and then pull grille-filter
forward.
• Remove and replace the exhausted outlet-filter.
• Push the grille filter, and then close the dust cover.
Page 6
2. Remove the carrying bag from the
cleaner.
4. Press the dust cover down gently
until the clamper relocks.
EN-5