Pontec PonDuett 3000 Instrucciones De Uso página 9

Intended use
PonDuett 3000,5000, referred to as "unit", may only be used as specified in the following:
· For cleaning garden ponds.
· For operation with clean water.
· Operate in accordance with instructions.
The following restrictions apply to the unit:
· Do not use in swimming ponds.
· Never use the unit with fluids other than water.
· Never run the unit without water.
· Do not use for commercial or industrial purposes.
· Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Assembly and installation
Screw either the nozzle tube (1) or the stepped hose adapter with O ring 12x4 (2) onto the connection thread. If you
use the nozzle tube, connect the desired fountain nozzle (3) to the connection socket (4). Place the unit in the pond as
horizontal as possible on firm, sludge-free ground and ensure that it is completely covered with water at a maximum of
2 meters below the surface of the water.
Commissioning/start-up
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
· Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
· Isolate the device (disconnect from the power supply) before carrying out any work on it.
N O T E
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical components.
· Do not connect the unit to a dimmable power supply.
Switching on: Connect the unit to the mains. The unit switches on immediately.
Switching off: Disconnect the unit from the mains.
Maintenance and cleaning
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
· Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
· Isolate the device (disconnect from the power supply) before carrying out any work on it.
Recommendation regarding cleaning:
· Clean the unit as required but at least twice a year.
· When cleaning the pump, pay particular attention to the cleaning of the impeller unit and pump housing.
· Do not use aggressive cleaning agents or chemical solutions as they could attack the housing or impair the function
of the unit.
· Recommended cleaning agent for removing stubborn limescale deposits:
– Vinegar- and chlorine-free household cleaning agent.
· After cleaning, thoroughly rinse all parts in clean water.
- EN -
9