Putting Into Use - Clatronic FR 3548 Instrucciones De Servicio

Putting into use

Electrical connection
• Make sure that the iron voltage (see name plate) and the
line voltage match.
• The mains plug should only be inserted into a correctly
installed socket with earthing contact.
Connected Wattage
The total power consumption of this device can be up to 2000 W.
With this connected load a separate supply line protected by a
16 A household circuit breaker is recommended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm
• Do not use any multiple sockets, as this device is too
powerful.
On/off switch
When the switch is in the position "OFF", the device is off.
There are two ways in which the device can be used:
Using without the timer switch
1. Move the on/off switch (7) to the "ON" position.
2. Select your desired temperature with the temperature
control (10).
Using with the timer switch
1. Select the desired cooking time with the timer switch (7)
(5 to 30 minutes).
2. Select your desired temperature with the temperature
control (10).
NOTE:
Once the time is up, a bell will sound. The device will switch
off automatically.
Use
1. Make sure that the appliance is unplugged and switched off
(The control lamps are off.).
2. Press button 11 to open the lid of the appliance.
WARNING:
• Always remove the mains plug before cleaning the device and wait
until the unit has cooled down.
• Never immerse the housing in water. This could lead to fire or elec-
tric shock.
34
3. In order to remove the deep fryer, place your hands in the
4. Fill oil or fat into the frying fat container. (maximum 3 l). The
5. Insert the plug in a duly installed protective contact socket.
6. Set the desired temperature on the temperature regulator
7. Turn on the appliance with the on / off switch. Either set the
8. Close the lid during the heating phase. Once the adjusted
9. Fill the frying basket. Open the lid and hang the basket with
2
.
10. Close the lid. Release the handle by sliding the button on
11. After the frying time has expired, you can allow the oil to
12. Open the lid carefully.
13. Now remove the deep-frying basket.
Ending operation
1. Switch the on/off switch to the "OFF" position.
2. Turn the temperature control and/or the timer back to the
3. Unplug the device from the mains.
4. Allow the frying oil a considerable time to cool down. Check
Cleaning
tub and pull the handle (13) upwards until it locks in place.
filling level must be located between the minimum and the
maximum level.
(10).
switch to the "ON" position or set a time. Both control lamps
will light up.
temperature has been reached, the HEATING control lamp
will go out.
the food to be fried onto the recess.
the handle (14). The frying basket is now in the hot fat.
NOTE:
During the deep-frying process the HEATING control
lamp switches on and off several times. This is normal
and it indicates that the temperature is controlled by the
thermostat and is being maintained.
drain off the deep-fried food. In order to do so, hang the
deep frying basket on the edge of the frying fat container
(as described under point 3).
WARNING:
As it is possible that hot steam will be released.
start.
if the temperature is safe before handling the full frying oil
pot further.