Replacing The Remote Control Battery; Disposal Of Used Batteries - Classic Flame 36EB110-GRT Manual De Instrucciones

NOTE: PLEASE OPERATE REMOTE TRANSMITTER
AT A SLOW MEASURED PACE. PRESS THE
REMOTE CONTROL BUTTONS WITH AN EVEN
MOTION AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID SUCCESSION
MAY CAUSE THE TRANSMITTER TO MALFUNCTION.
Note: When a function is changed from the control
panel or remote control there will be a corresponding
indicator (see Figure 6) on the upper-right of the
projection screen. The indicator shows the function
changed and the level selected by the control panel or
remote control. When the function is turned off, the
corresponding indicator will flash 5 times and then
fade off.

REPLACING THE REMOTE CONTROL BATTERY

When the remote control stops operating or its range seems
reduced, it is time to replace the battery with a new one.
1. The battery compartment is located on the back end of the
remote.
2. Press and slide the battery door open and remove
the old battery.
3. Insert a CR2032 battery， checking that the + and - sides
of the battery match inside the battery compartment.
4. Replace the battery compartment door.

DISPOSAL OF USED BATTERIES

Battery may contain hazardous substances
which could endanger the environment
and human health.
This symbol marked on the battery
and/ or packaging indicates that used
battery shall not be treated as municipal
waste. Batteries should be disposed of
at an appropriate collection point for
recycling.
By ensuring the used batteries are disposed of correctly, you will help prevent potential
negative consequences for the environment and human health. The recycling of materials
will help to converse natural resources.
For more information about recycling of used batteries, please contact your local municipality waste
disposal service.
As an important safety feature, the heating element is designed with a delayed activation sequence.
Therefore, when the heater is turned ON it will take several minutes for the unit to begin blowing hot air.
Subsequently, the fan blower will continue to run for several minutes after the heater is switched OFF.
If heater doesn't work, but Power and Heater switches are in the "ON" position and thermostat is set
on "HI", the product is on the protected status, then turn all switches to the "OFF" position and
unplug the unit from the wall outlet for 30 minutes. After 30 minutes plug the unit back into wall outlet,
and operate as normal.
Figure 6: Remote Control
36EB111-GRC
36EB221-GRC
HEAT
FLAME
TIMER
COLOR
DOWN
FLAME
LIGHTS
LEVEL
UP
AUTO
LIGHTS
on the upper-right of front projection screen
E-5
36EB110-GRT
36EB220-GRT
HEAT
TIMER
FLAME
EMBERS
Figure 7