Cycle Computer Warning Codes - PIVOT cycles PIVOT SHUTTLE Team XTR Manual Del Usuario

Cycle Computer Warning Codes

Warnings may appear on the cycle computer display if the system
detects an issue.
The warning code will clear once the issue is resolved.
If any issues persist a er the sugges
of purchase.
Drive unit opera
ture is higher than normal
Traveling speed cannot be
detected
Torque sensor was not ini
properly
Electronic derailleur installed in
place of a mechanical derailleur
Cycle Computer Error Codes
An error message may appear on the cycle computer if the system
detects an issue.
If any issues persist a er the sugges
of purchase.
A system error was detected
An error occurred in system opera on
An anomaly was detected in the drive
unit's rmware
The speed sensor may be installed in the
wrong posi on
A communica on error between the bat-
tery and drive unit was detected
Ba ery connected to the drive unit is not
supported
The ba ery connected does not conform
with system standards
Part of the cycle computer's rmware
may be damaged
www.pivotcycles.com
s below, contact the place
tempera- Power assistance may be lower
than usual
Maximum speed may be lower
than usual
zed Power assistance may be lower
than usual
Power assistance provided in
[WALK] may be lower than usual
s below, contact the place
Power assistance is not
provided during riding
Power assistance is not
provided during riding
Power assistance is not
provided during riding
Power assistance is not
provided during riding
Power assistance is not
provided during riding
Power assistance is not
provided during riding
All system func ons
shutdown
Power assistance is not
provided during riding
service-eu@pivotcycles.com
TROUBLESHOOTING
Stop using the assist func on un l the
drive unit temperature drops.
Check that the speed sensor is installed
correctly.
Change the assist switch to the gear shi -
ing switch and turn the power on again.
Reinstall the derailleur for which the sys-
tem is con gured to support.
Press the power n of the
turn it on again.
Press the power n of the
turn it on again.
Contact the place of purchase.
Contact the place of purchase.
Check that the cable between the drive
unit and ba ery is properly connected.
Press the power n of the
turn it on again.
Press the power n of the
turn it on again.
Contact the place of purchase.
+49 711 4905 9800
ery to
ery to
ery to
ery to
10