Before First Use; How To Make Coffee; Cleaning And Maintenance - STARFRIT 024002 Instrucciones De Uso

BEFORE FIRST USE

READ THE INSTRUCTIONS BEFORE USE
NOTE: Remove all parts & accessories and dispose of packaging.
Check that all accessories are complete and the unit is not damaged. Add water into water tank
to the max level and brew water for several times without coffee powder, then discard the water.
Clean all detachable parts thoroughly with warm water.

HOW TO MAKE COFFEE

A. Open the top lid and fill the water tank with drinking water. The water level should not exceed
the "Max" level as indicated in the water tank. (Fig. 1)
B. Place the permanent filter and funnel in the funnel support, make sure it is
assembled correctly, otherwise the cover will not close properly. (Fig. 2)
C. Add coffee grounds into permanent filter. Usually 1 level tablespoon of
medium coffee grounds requires 1 cup of water for each cup of brewed
coffee. However, you can adjust according to personal taste.
D. Insert a conventional coffee mug or the travel mug under the water tank
horizontally.
E. Plug the power cord into the outlet.
F. Press the switch, the indicator will light up in red and the appliance will
start working.
G. After brewing is complete, the indicator light will extinguish indicating
your coffee maker is turned off.
H. Remove mug to serve or drink when brewing is complete (about one minute after the coffee
stops dripping out.) NOTE: The volume of coffee you get will be less than the water you have
added, as some water is absorbed by the coffee grounds.
I. Always turn the coffee maker off and disconnect the power supply when not in use. NOTE:
Pay close attention when serving or drinking coffee. Once the brewing is over, the coffee's
temperature will be very high.

CLEANING AND MAINTENANCE

CAUTION: Be sure to unplug this appliance before cleaning. To protect against electrical shock, do
not immerse cord, plug or unit in water or any other liquid. After each use, always make sure plug is
first removed from wall outlet.
1. Clean all detachable parts after each use in hot soapy water.
2. Wipe the exterior surface of unit with a soft, damp cloth to remove stains.
3. Water droplets may buildup in the above area of the funnel and drip onto the product base
during brewing. To control the dripping, wipe off the area with a clean, dry cloth after each
use.
4. Use a damp cloth to gently wipe the mug rest and travel mug. Never use an abrasive cleaner.
5. Assemble all parts and put aside for next use.
5