System Installation - Ceasa OSMOTIC Manual De Instrucciones

4.

SYSTEM INSTALLATION

An authorized technician must be in charge of installing the equipment according to individual state
regulations.
Follow the indications in the figures carefully.
Step 1
1.- Drill a hole in the surface of the sink
with a 19 mm diameter bit.
Step 4
4.- Disconnect the entry valve from the sink
faucet.
Step 7
7.- Mount the waste pipe connection kit to
the waste pipe.
Step 2
2.- Introduce the faucet through the
hole.
Step 5
5.- Install the double entry valve on
the main cold water outlet. Connect
the sink faucet to the double entry
valve.
Step 8
8.- Attach the sink faucet to the
double entry valve installed in Step 5.
Attach the OSMOTIC's inlet tube
(black tube) with pressure reducer to
the double entry valve.
Step 3
3.- Mount the faucet with the
components indicated in the figure
in the same order.
Step 6
6.- Drill a hole in the waste pipe with
a 7,2 mm diameter drill bit.
Step 9
9. Connect the Osmotic's reject tube
to the waste pipe
installed in Step 7, and the other end
of the tube to the OSMOTIC (red
tube).
connection
53