Dometic PerfectView CAM360AHD Instrucciones De Montaje página 20

Installing the video system
A
NOTICE! Damage hazard
• The system may only be permanently installed after a successful test
calibration.
• Before drilling or screwing, ensure that the respective cable lengths
are long enough.
• To prevent damage when drilling, ensure there is sufficient space on
the other side for the drill head to come out (fig. 3, page 5).
• Deburr all drill holes and treat them with a rust-protection agent.
I
NOTE
If installing the camera alters the vehicle size specified in the vehicle doc-
uments, your vehicle must be inspected by the appropriate authorities.
This authority must note any such changes in your vehicle documents.
Please note the following:
• When working on the following cables, only use insulated cable terminals, plugs
and flat sockets:
– 30 (direct supply from positive battery terminal, acts as storage buffer for date
and time)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– Reversing light
– Left/right indicators
Do not use porcelain wire connectors.
• Use a crimping tool (fig. 2 7, page 4) to connect the cables.
• Screw the cable when connecting cable 31 (earth)
– using a cable terminal and serrated washer to one of the vehicle's earth bolts
or
– screw the cable to the bodywork using a cable terminal and a self-tapping
screw
Ensure there is a good earth connection.
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
• The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the operating manual.
20
CAM360AHD
EN