Dometic PerfectView CAM360AHD Instrucciones De Montaje página 34

Video system settings
➤ Check whether the camera angles are set so that two white rectangles on the
calibration mats can be seen completely.
➤ If necessary, change the position of the calibration mat.
➤ Measure the dimensions W and L in meter (fig. m, page 11).
➤ Enter the dimension W in m for the "WIDTH".
➤ Enter the dimension L in m for the "LENGTH".
➤ Select "FRONT TRACKING".
CURRENT SETTING POINT: 1
1
5
6
✓ The view changes to the front camera. Eight red crosses and a zoom window are
layered on top of the camera image. The zoom window shows an enlarged view
of the currently active cross. The active cross is blinking.
➤ Position the crosses with the arrow keys on the remote control.
– The crosses must be positioned on the corners of the white squares on the
calibration mats.
– Confirm the position of each cross with the remote control (press „OK").
– After confirmation the colour of the active cross changes from red to green
and the next cross becomes active.
➤ Repeat this process for „REAR TRACKING", „LEFT TRACKING" and
„RIGHT TRACKING". For each camera you have to adjust 8 crosses, 32 in total.
➤ Select "CALIBRATION".
34
2
CAM360AHD
LEFT
3
4
8
7
EN