Correct Exposure Indication; Af Measuring Beam; Special Functions; Bleep Function (Acoustic Alarm) - Metz MECABLITZ 70 MZ-4 Manual De Instrucciones

Ensure that a sufficiently slow shutter speed is set on the camera.
Table 3 specifies the fastest camera shutter speeds for the N - f(Hz) combina-
tions.

10. Correct exposure indication

The correct exposure indicator "o.k." only lights up if the picture was correct-
ly exposed in automatic or TTL flash mode.
This gives the user the opportunity to fire a test flash while in automatic flash
mode so that the correct aperture can be established beforehand. This is par-
ticularly valuable with bounce flash when reflection conditions are difficult to
judge. A test flash cannot be fired in TTL mode.
The test flash can be triggered with the manual firing button.
If the ok exposure indicator remains dark after the test flash was fired, then
adjust the next lower f-number, or diminish the distance to the reflecting sur-
face or subject, and repeat the test flash.
The f-stop established in this manner must also be set on the camera.
To trigger a test flash, hold the camera and flash unit in the same
manner as for the actual shot!
This facility can also be used with TTL mode without having to produce test
exposures. The flash unit is adjusted to automatic mode, and the correct
aperture is then determined with a test flash in the previously described man-
ner. The established aperture is transferred to the camera and the flash unit is
then readjusted to TTL mode.
This procedure is relatively accurate with lenses of medium focal length of
between 28 mm and 85 mm. However, in borderline cases, underexposure
may result in TTL mode. In such an event the ok exposure indicator will re-
main dark after the shutter has been released. Select the next larger aperture
(e.g. f/8 instead of f/11) and have another try.

11. AF measuring beam

The AF measuring beam can only be activated by autofocus cameras
that support the AF measuring beam of the flash unit! Some autofocus
cameras only support their own built-in AF illuminator (refer to the
operating instructions for the given camera). The mecablitz must be
fitted with an SCA 3xx2 adapter!
Please note when selecting the camera's autofocus mode that most cameras
only support the AF measuring beam in the „Single AF" or „One-Shot AF"
mode (see operating instructions for the camera)!
The AF measuring beam is activated by the camera electronics when the
ambient lighting conditions are insufficient for automatic focusing. The AF
beam projects a striped pattern on to the subject, and the camera uses this
pattern to focus automatically. The AF beam has a range of 9 m (with a
50 mm f/1.7 standard lens). Low-speed zoom lenses can significantly curtail
the range of the AF measuring beam.
Some autofocus cameras have several AF metering fields in addition
to the central AF metering area in the camera's viewfinder. The striped
pattern of the AF measuring beam only supports the camera's central
AF sensor. Consequently it may be necessary to adjust the central AF
sensor manually on the camera (see the operating instructions for the
given camera and the SCA adapter).

12. Special functions

The special functions of the mecablitz can be called, one after the other, by
depressing the Select button, and they can be set, switched off and stored
with the setting disk.
12.1 Bleep function (acoustic alarm)
(not possible with 70 MZ-4)
The bleep function is used to acoustically indicate certain mecablitz func-
tions. It enables the photographer to concentrate fully on the subject without
being distracted by the need to observe additional visual status displays!
k
101