Siemens Euroset 3010 Instrucciones De Manejo página 4

mode with the flash time of 270 ms
(DTMF).
Checking the dialing mode:
Press any numeric key. If you can still hear
a dialing tone, change to the other dialing
mode.
Changing the dialing mode:
To adjust the dialing mode to PULSE or
TONE, proceed in the following way:
Lift the handset
Press the PROG key
Press the key
Press the digit 1 to change to TONE or
:
the digit 2 to change to PULSE
Press the PROG key
Hung up
Temporary changeover of dialing mode:
While the telephone is set to PULSE dialing
it may be necessary to temporarily change
the dialing mode to TONE dialing.
• Example: You wish to check your
banking balance using the telebank
service. Make the call as you usually
would and, as soon as the call is
complete, press ; at this moment your
telephone dialing mode will change to
TONE dialing. When you finished the
call, just hang up and the dialing mode
will automatically turn back to PULSE
dialing.
Setting the ringer volume and melody
This telephone offers three melodies and
three different ringer volumes.
Setting the ringer volume:
Lift the handset
Press the PROG key
Enter one of the codes below, in
according with the desired option:
• 51 low volume
• 52 medium volume
:
• 53 high volume
Press the PROG key
Listen the confirmation tone - long
beep
Hung up
Note:
The volume can also be programmed while
the telephone is ringing, without lifting the
handset. In this situation, the key
selects cyclically the 3 available volume
levels.
Setting the melody:
Lift the handset
Press the PROG key
Enter one of the codes below, in
according with the desired option:
• 61 melody 1
• 62 melody 2
:
• 63 melody 3
Press the PROG key
Listen the confirmation tone - long
beep
Hung up
Note:
The melody can also be programmed while
the telephone is ringing, without lifting the
handset. In this situation, the key
selects cyclically the 3 available melodies.
REDIAL key
In order to redial the last dialed number, lift
the handset and press the REDIAL key
If the last dialed number contained more
than 32 digits, the REDIAL function will not
work
3
.