Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The flow of heat stops during
There is no cookware on the
E0
E2
under the hob is defective or
there has been a short circuit.
E3
E4
E5, E6
16
cooking.
hob or the cookware is not
suitable for use with the
induction hob.
The temperature sensor
The hob is receiving too
much voltage.
The hob is not receiving
enough voltage.
The hob has overheated.
The appliance's overheat
protection may have been
activated. Disconnect the
hob from the power supply,
then reconnect the power
supply and restart the ap-
pliance. The appliance must
not be continuously operated
for more than 2 hours. The
vent ilation openings must
not be blocked or dirty. Make
sure that the ambient temp-
erature is not too high.
Place suitable cookware on
the hob.
Remove the plug from the
outlet and contact customer
service.
Make sure the hob is plugged
into a 220-240 V, 50-60 Hz
outlet.
Make sure the hob is plugged
into a 220-240 V, 50-60 Hz
outlet.
Remove the plug from the
outlet and let the hob cool
down. If the problem persists,
please contact customer
service.
Publicidad
Tabla de contenido
