Operation; Charger Wall Mount; Service And Maintenance; Accessories - Festool MXC Manual De Instrucciones Original/Lista De Piezas De Repuesto

GB
MXC
6

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident
X The mains voltage and the frequency of
the power source must correspond with
the specifications on the machine's name
plate.
X In North America, only Festool machines
with the voltage specifications 120 V/60
Hz may be used.
6.1 Charging the battery pack
Charge only battery packs that are
designated for use with the charger.
(see Technical data)!
The LED [1-3] on the charger indicates the
respective operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Battery pack will be charged with max. cur-
rent.
LED green - flashing slowly
Battery Pack is charged to 80 % and will be
charged with further reduced current.
LED green - lit continuously
Battery pack is fully charged.
LED red - lit continuously
Battery temperature is outside the permitted
range (0 °C to 45 °C).
LED red - flashing
General fault display, e. g. incomplete con-
tact, short circuit, battery pack faulty, etc.
6.2

Charger wall mount

The charger MXC has two elongated holes on
its back. It can be mounted on a wall using
two screws (e.g. round head or flat head
screw with shank diameter of 5 mm) (see
Fig. [1]).
10
7

Service and maintenance

Observe the following instructions:
– Keep the air slits on the machine and the
charger free and clean to ensure adequate
cooling.
– Keep the contacts on the machine, charger
and battery pack clean.
8

Accessories

Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
[1]
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers of the accessories and
tools can be found in the Festool catalogue or
on the Internet under "www.festool.com".
9

Disposal

Do not throw the tool in your household
waste!! Dispose of machines, accessories
and packaging at an environmentally re-
sponsible recycling centre. Observe the valid
national regulations.
EU only: European Directive 2002/96/EC
stipulates that used electric tools must be
collected separately and disposed of at an
environmentally responsible recycling cen-
tre.
10

Warranty

We offer a warranty for material and produc-
tion defects for all our tools in accordance
with the locally applicable legal provisions,
but for a minimum of 12 months. Within the
EU member states, the warranty period is 24
months (verification through invoice or deliv-
ery note). Damage caused by the operator,
natural wear, overloading, incorrect handling
or through the use of the equipment not
specified in the operating manual, or damage
which was known at the time of purchase, is
not covered by the warranty. Furthermore,
damage caused by the use of non-original
accessories and consumable materials (e.g.
sanding pads) is also excluded.