Bresser 33-10100 Instrucciones De Uso página 27

Mode
Image
Video
File format
2. Important notes
• The working voltage of the camera is 6V. The camera
is supplied by four AA batteries.
• Please install batteries according to shown polarity.
• For camera operation an SD-card* (8 MB to 32 GB) is
needed.
• Please unlock the write-protect before inserting the
SD-card.
• Please insert the SD-card when the power switch is at
OFF position before testing the camera. The camera
has no internal memory for saving images or videos.
• Please do not insert or take out the SD-card when the
power switch is at ON position.
• It is recommended to use the camera to format the
SD-card when used for the first time.
Format
JPG
AVI
FAT32
• The camera will be in USB mode when connected to
a USB port of a computer. In this case, the SD-card
functions as a removable disk.
• In the TEST mode (insert the control into the USB in-
terface then switch the camera at ON position), the
camera will shut down automatically after 3 minutes if
no operation is done. Please turn on the power again
if you want to continue to work with the control.
• Please ensure sufficient power when having firmware
upgrade, otherwise the upgrade process could be in-
terrupted incorrectly. If any fault occurs after improper
upgrading process, the camera may stop function
properly.
• When the camera is taking a picture or video, then this
action should end first. If you connect the handbox
at this point, then the LCD panel will illuminate white.
Please remove the handbox, wait a little bit and then
connect the handbox again.
GB
27