Clatronic BS 1222 Instrucciones De Servicio página 41

42880-05-BS 1222
Accessory compartment:
The incorporated accessory (upholstery nozzle, crevice nozzle) is located in the
accessory compartment on the back of the device.
Carrying belt:
You can comfortably hang the appliance with the supplied carrying belt. Fasten the
belt to the envisaged fastening points on the bottom of the appliance.
Winding device for the power cable:
Unwinding: Pull out the length that you require. The maximum length is shown by a
marking on the cable. Do not pull any further! The winding device could be dama-
ged otherwise.
Rewind: Press the button (9) to rewind the cable and guide the cable.
Nozzle sets:
Narrow nozzle: for vacuuming in corners and grooves, for example
Upholstery nozzle: To clean upholstery.
Floor nozzle: To clean carpets or smooth surfaces. The floor nozzle (1) is equipped
with brush wheels and is adjustable for the relevant operating mode.
The nozzle can be set for the relevant type of operation.
Carpets: Press the lever with the symbol for uneven surfaces down with your
foot.Smooth
floor: press down the other lever. The levers change over.
Undoing the units: pull them apart while twisting slightly.
Dustbag indicator:
Hold the hose into the air. If the dust bag full display (11) lights up, the bag is full.
Changing the dustbag:
• Pull the plug out of the socket.
• Open the cover (13) of the dust bag compartment.
• Then pull the bag out.
• As the bag is locked in place it is necessary to use a little force to remove it.
• Push a new bag in. Close the cover again so that it clicks into place.
Air outlet filter:
Replace the filter at the air outlet after the 10th time that the dustbag has been
changed. Fold up the black lid, remove the filter and insert a new one. Press the lid
until it locks in place.
Damper:
10.03.2004 12:40 Uhr Seite 41
GB
41