2610051871.qxp_GAL18V-160C 4/27/20 11:08 AM Page 4
Extension Cords
UNLESS ABSOLUTELY NECESSARY. Use of
improper extension cord could result in risk
of fire and electrical shock. If an extension
cord is used, make sure:
a.
The pins on plug of extension cord are
the same number, size, and shape as
those of plug on charger.
b.
The extension cord is properly wired and
in good electrical condition.
c.
The wire size is large enough for AC
ampere rating of charger as specified
below:
Length of
25
Cord, Feet
AWG Size
18
of Cord
d.
An extension cord is a temporary
solution. Move the charger to a standard
receptacle as soon as the job has been
completed.
Important Charging Notes
1.
The charger was designed to fast charge
the battery only when the battery
temperature is between 32˚F (0˚C) and
113˚F (45˚C). If the battery pack is too
hot or too cold, the charger will not
begin charging the battery. (This may
happen if the battery pack is hot from
heavy
use).
temperature returns to its safe charging
temperature, between 32°F (0°C) and
113°F
(45°C),
automatically begin charging.
2.
A substantial drop in operating time per
charge may mean that the battery pack
is nearing the end of its life and should
be replaced.
3.
Remember to unplug charger during
storage period.
4.
If battery does not charge properly:
a. Check for voltage at outlet by plugging
in some other electrical device.
Charger Safety Rules
AN EXTENSION CORD
SHOULD NOT BE USED
50
100
150
16
16
14
Once
the
battery
the
charger
will
SAVE THESE INSTRUCTIONS
b. Check to see if outlet is connected to
a light switch which turns power "off"
when lights are turned off.
c. Check battery pack terminals and
charger connectors for dirt. Clean with
cotton swab and alcohol if necessary.
d. If you still do not get proper charging,
take or send tool, battery pack and
charger to your local Bosch Service
Center. See "Tools, Electric" in the
Yellow Pages for names and addresses.
Note: Use of chargers or battery packs not
sold by Bosch will void the warranty.
Electronic Cell Protection (ECP)
The lithium ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is
empty, the tool is switched off by means of
a protective circuit.
The battery is supplied partially charged.
Completely charge the battery before using
your cordless power tool for the first time.
The lithium ion battery can be charged at
any time, without reducing its service life.
Interrupting the charging procedure does
not damage the battery.
4