Bosch GAL18V-160C Instrucciones De Funcionamiento Y Seguridad página 7

2610051871.qxp_GAL18V-160C 4/27/20 11:08 AM Page 7
GCY42 Connectivity Module
Installation (sold separately)
operating instructions included with
Bosch GCY42 connectivity module.
Operating instructions
connectivity module include important
information not covered in this manual.
If GCY42 connectivity module is not
purchased with the charger, or if the
replacement of the module or the battery
becomes necessary, please follow this
procedure (See Fig. 2):
- Using a flat screwdriver or a coin,
remove the cover A from the top of the
unit, by turning it 1/4 turn counter-
clockwise.
- If the charger is already equipped with
the connectivity module, remove the
battery B, but do not remove the
connectivity module C.
- If the connectivity module is installed for
the first time, remove the plastic
placeholder D from the connectivity
module compartment, and place the
connectivity
compartment
orientation. Note: Store the placeholder
D in a safe place. Reinsert the
placeholder again if the communications
module is removed.
- Next place new battery B on the top of
the connectivity module with the "+"
polarity facing up.
- Place the cover A over the battery and
turn it ¼-turn clockwise to lock using a
flat screwdriver or a coin.
Assembly
To reduce the risk of
injury read the
for GCY42
module C in the
observing correct
Fig. 2
7
A
B
C
D