Brother P-touch EDGE 7500 Guía De Usuario página 40

Setting bar code parameters
Press g, then c.
1
Press l or r until the parameter that you wish to change is displayed.
2
Press u or d until the desired setting is displayed.
3
4
Repeat steps
Press n.
5
Entering bar code data
Press c.
1
2
Type in the new bar code data or edit the old data.
Press n to add the bar code to the text.
3
☞ To add special characters to the bar code data (only with protocols CODE39,
CODABAR, EAN128 or CODE128), position the cursor below the character
immediately to the right of where you wish to add the special character, and then
press s. Press u or d until the desired control character is displayed, and
then press n to add the character to the data. (Refer to the tables below for a list
of the special characters that are available.)
☞ To change the data or WIDTH or UNDER# parameter settings of a bar code that has
already been added to the text, position the cursor below the bar code mark (
g
then press
The following control characters can only be added to bar codes created using protocol
CODE39 or CODABAR.
Symbol Character
–
0
1 .
2 (SPACE)
3 $
24
2 3
and until all parameters are set as you wish.
c
, then .
CODE39
Symbol Character
4
5
6
Symbol
/ 0
+ 1
% 2
CODABAR
Character Symbol
–
3
$ 4
: 5
), and
Character
/
.
+