Placement Of Mounting Plate; Removing The Mounting Plate; Finding The Wall Studs - GE JVM3160RF2SS Instrucciones De Instalación

PLACEMENT OF THE MOUNTING PLATE
1
A REMOVING THE MICROWAVE OVEN
FROM THE CARTON/REMOVING THE
MOUNTING PLATE
1
Open the box and fold back all four carton flaps
fully against the carton sides. Remove the following
items from the protective foam: installation
instructions, filters, exhaust adaptor, damper, and
the small hardware bag. Do not remove the foam
protecting the front of the microwave oven.
Then carefully roll the microwave oven and carton
over onto the top side. The microwave oven
2
should be resting in the foam.
Foam
3 Pull the carton up and off the microwave oven.
4
The mounting plate is attached to the back of the
microwave oven. Remove the two screws holding
it to the microwave oven. The plate will be used
as the rear wall template and for mounting the
microwave oven to the wall.
5 Set the microwave oven upright. Remove and
properly discard plastic bags and foam.
6 Open the microwave oven door and remove the
plastic sheet and tape from inside the microwave
oven door. Remove the tape covering the turntable
hub.
Installation Instructions
Carton

FINDING THE WALL STUDS

B
Wall
Studs
Center
1
Find the studs, using one of the following methods:
A. Stud finder.
B. Use a hammer to tap lightly across the mounting
surface to find a solid sound. This will indicate
a stud location.
After locating the stud(s), find the center by probing
2
the wall with a small nail to find the edges of the
stud. Then place a mark halfway between the
edges.
The center of any adjacent studs should be 16 or
24 from this mark.
3
Draw a line down the center of the studs.
IMPORTANT: The microwave must be connected to
at least one wall stud.
9
OR