Carat C 2067 Manual De Instrucciones página 31

6. Check prior to use
THE C 2067/90 IS DESIGNED TO WORK WITH
WATER.
1 1 1 1
Before starting to cut make sure that the water level
in the tank is as shown. (Photo 11)
ADJUSTMENT OF THE REFRIGERATION WATER.
Using the shut-off valve located above the disc
guard it is possible to vary the amount of water
according to the type of material to be cut.
(Photo 12)
This is made possible by the innovative refrigeration
system "Spray System" that allows the disc to be
constantly wet.
1 1 2 2
7. Making flat cut
The versatility of the C 2067/90 makes it possible to
make different types of cuts.
Position the piece to be cut on the work surface
making sure that it is properly supported by the tile
clamp if necessary using the support square to help.
(Photo 13)
1 1 3 3
WARNING !
THE MILLIMETRE RULE ON THE WORK
SURFACE IS ONLY TO BE USED FOR MAKING
LINEAR CUTS.
For making diagonal cuts, rest the tile against the
square as shown and proceed with the cut.
(Photo 14)
1 1 4 4
8. Making 45° cut (jolly)
WARNING !
Before positioning the motor head, make sure
that:
- The machine is switched off.
- The cutting tool is not moving.
Making reference to the graduated scale on the
machine's upright, bring the motor head into the
JOLLY position and tighten the knobs. (Photo 13)
Using the locking lever, lower the cutting head
bringing the disc a few millimetres below the level
of the surface.
31
GB