Carat C 2067 Manual De Instrucciones página 33

- Position a reference well lined up on the cutting
line of the tool. (Photo 17)
1 1 8 8
- Insert the 5 mm hexagonal male wrench
provided in the hexagonal slot located on the
bulb. (Photo 18)
- Use the hexagonal wrench to turn the bulb until
the mark is aligned with the cutting axis of the
tool. (Photo 17)
WARNING !
WHEN ADJUSTING, ENSURE THAT THE LINE
PRODUCED BY THE MARKER DOES NOT
SHINE IN THE OPERATOR'S EYES.
WARNING !
THE MANUFACTURER
RESPONSIBILITY WHERE THE LASER MARKER
IS USED OTHER THAN AS INDICATED.
10. Maintenance
DISASSEMBLING THE DIAMOND DISC
Loosen the two nuts on the disc guard and remove
the guard. Remove the disc-locking nut using a 19
mm spanner and a 5 mm Allen wrench.
WARNING !
THE DISC LOCKING NUT HAS A LEFT-HAND
THREAD.
ACCEPTS NO
33
1 1 9 9
After disassembling the disc, carefully clean the disc
holding flanges and check for any wear.
Lubricate the surfaces with fine oil and proceed to
assemble the new disc, paying attention to the
rotation direction clearly printed on the tool.
ADJUSTING THE CARRIAGE
The motor carriage has two registers for calibrating
the vertical play of the motor head.
For correct adjustment, proceed as follows:
- With a 3mm hexagonal male wrench, screw the
two front adjustment set screws (A), until the
play is eliminated; (Photo 20)
2 2 0 0
- Repeat the operations for the two rear
adjustment set screws (B). (Photo 21)
2 2 1 1
GB