Mounting The Attachment - Stihl BF Manual De Instrucciones

Loop-handled machines without
barrier bar
On the following machines the standard
loop handle must be removed and
replaced by a loop handle with barrier
bar:
STIHL FC 83, STIHL FC 85,
STIHL FC 110, STIHL KW 85
The barrier bar cannot be mounted
to the standard loop handle.
To retrofit the loop handle see chapter
on "Mounting the Loop Handle".
Other combinations of the
attachment and non-approved basic
power tools are not permitted since
they may result in accidents or
serious personal injury.
BF, BK

Mounting the Attachment

English / USA
Preparations
: Loosen the clamp screws on the
basic power tool's gearbox housing
and pull the gearbox off the drive
tube.
The drive shaft may slip out of the
tube in this process. If this happens,
push the drive shaft back into the
tube.
L
: The drive shaft must not project
from the tube more than distance L
(25mm/1in).
: If this dimension is not correct, apply
slight pressure to the drive shaft and
rotate it slowly at the same time until
it can be pushed in to the required
length.
13