Wiring Diagram - Velleman SP500B Manual Del Usuario

Press button II (the smaller one) to enter the menu for selecting the shock sensitivity. Press button II again to scroll
through 8 levels and the 8 corresponding tones. The higher the pitch of the tone, the higher the sensitivity.
TESTING THE SENSITIVITY
1) slap the bonnet with the flat of your hand to simulate an intruder. The alarm should beep once to warn off the
intruder. Start the entire programming procedure again if no beep is heard.
2) slap the windshield with the flat of your hand to simulate an intruder trying to break the windshield. The alarm
should beep once to warn off the intruder. Start the entire programming procedure again if no beep is heard.
3) The alarm should go off for real (ding dong) if the shock the vehicle is subjected to is sufficiently severe.
Important remark : The sensitivity is too low if you only hear a beep after a severe shock; the sensitivity is too
LEAVING THE PROGRAMMING MODE
Simply press button I to exit the programming mode and save the sensitivity level. Two beeps confirm the setting.
The device automatically leaves the programming mode if no button is pressed for 10 seconds.
C. Choosing the alarm tone – 5 tones and 1 multi-alarm tone
After disarming the alarm you have 10 seconds to enter the programming mode for the alarm tone. Hold both buttons
simultaneously. A single beep confirms that the programming mode is now activated. Press button I to select the
various alarm tones (5 tones + 1 multi-alarm tone). When you have found the one you want just press button II to
leave the programming mode. The last tone you've listened to has been programmed as your alarm tone. Two beeps
confirm that you have left the programming mode.

Wiring Diagram

Operation
A. Transmitter
1. Press button I once = activate/deactivate alarm
2. Hold button I for 3 seconds = panic alarm
3. Activate the alarm and press button I within 3 seconds = alarm is activated and the shock sensor is deactivated
4. Hold button II for 2 seconds: the parking lights will flash for 15 seconds and the siren will produce 3 beeps. This
function makes it easy to find the vehicle in a parking lot.
5. Press button II once, then press button I = activate/deactivate alarm without "beep" warning.
6. Press both buttons to enter the programming mode
SP500B
high if the alarm goes off full tilt after a mild shock. Place the sensitivity in the minimum
position required to effectively protect your vehicle.
5 VELLEMAN