Olymp LavaSit COMFORT Instrucciones De Servicio página 10

C Use the „Prog." (C) button for the massage programme:
Press button 1x
Press button 2x
Press button 3x
Press button 4x
Press button 5x
D By means of the „STOP" button (D) you can switch off all massage programmes at any time.
(Massage unit returns to park position). During this period (approx. 15 Sec.) the footrest
cannot be operated! To provide a comfortable exit from the wash unit for the clients, you
have to remove the footrest (B) and after that you have to switch off the massage function (D).
• The massage function switches off automatically after 16 minutes. It can be restarted immediately
using button „Prog." (C).
• The remote control is held magnetically at the holding button at the side of the backrest on the left
and the right (Fig. 8).
Important user information regarding the remote control:
The wash-basin remote control unit is designed exclusively for the use of clients with dry
hands. To guarantee correct operation of the electronic components, the remote control
unit must in no circumstances be allowed to come into contact with water, shampoo or
other fluids.
If it is operated with hands covered in foam, or with dirty hands, the remote control unit
will not operate correctly, there will be lasting damage to the electrical components, and the keys may
become permanently soiled.
The guarantee does not cover damage to the electronics as a result of the effects of
wetness!
If, in exceptional circumstances, stylists need to operate the remote control themselves, it is essential
that the plastic cover be used.
3. Base
The installations and corner valves are located in the base behind the inspection cover.
Please Note: We recommend fitting the feed pipes with an „Aqua-Stop" unit.
If the equipment is operated without an „Aqua-Stop" the main tap must be closed after work is finished.
a. Inspection cover (fig. 4)
• To open, grasp the upper recess and pull to release magnetic connector, then lift out of the
lower seating.
WARNING: Always isolate the complete system and secure against unintended
switch-on before opening the inspection cover!
• When closing the cover first align below and afterwards click back into the magnetic connector
above.
GB
= Programme 1 „Energy":
> powerful massage over the whole back
> control lamp „Energy" (E) lights up:
= Programme 2 „Dream":
> light massage over the whole back
> control lamp „Dream" (F) lights up
= Programme 3 „Relax":
> medium strength massage over the whole back
> control lamp „Relax" (G) lights up
= Programme 4 „Backflex":
> stretching of the lumbar vertebrae only
> control lamp „Backflex" (H) lights up
= return to programme 1
3