Genesis GTS10SB Manual Del Operario página 15

NOTE: The miter gauge body (2) has marks at 5 degrees
increments. The sliding bar (3) has marks at 1 degree
increments. Read both to get an accurate angle degree.
To adjust the Miter gauge Fence, loosen the lock
knob (4) and slide the fence (5) to the desired position. Then
tighten the lock knob (4). (See FIG 12)
RIP FENCE INSTALLATION (FIG 13)
The rip fence is pre-assembled at the factory. To install the
Rip Fence, place the end furthest (2) from the lock handle (1)
so that flange is over the rear edge of the table, then lower
the end closest to the handle over the front rail. When the
Lock down handle (1) is in the uP position, the flanges are
relaxed, allowing you to re-position the Rip Fence. When the
Lock down handle is in the DOWN position, the flanges are
locked with rails in place. (See FIG 13)
warning:
parallel with the Saw blade in order to prevent
Kickback when rip cutting.
RIP FENCE ADJUSTMENT (FIG 13)
warning:
always unplug the saw from power source
before make any adjustments.
To adjust the rip Fence, lift the lock handle (1) to the uP
position. use indicator (3) on the fence to slide the Rip Fence
to desired position. Make sure the front bar on the Rip Fence
is flush against front rail. Then lock DOWN the lock handle.
To adjust the tension on the rip Fence, you may
turn the tension adjustment knob (4) clockwise to increase
the tension or turn counterclockwise to decrease the tension.
To align rip Fence, please follow the steps below:
1. Lift the lock handle (1) to uP position.
2. Slide the Rip Fence by the handle until it is alongside the
saw blade. The fence should touch the "SeT" teeth at the
front and rear of the blade. If not, continue the following
the steps.
3. Loosen the two hex screws (5) on the top front section of
the fence.
4. Move the fence until it touches the teeth and is parallel to
the blade.
5. Hold the fence in place and lower the lock handle, then
tighten hex screws.
The distance of the Rip Fence body from the blade when rip
cutting on the right side of the blade is determined by aligning the
Distance Indicator (3) with the desired dimension on the scale( 6).
To adjust the Rip Fence Distance Indicator, loosen the adjustment
screw (7), adjust the indicator (3) and then tighten the screw (7).
The rip Fence must be
To prevent personal injury,
3
4
2
2 3
2
6 3 7
1
5
FIG 12
5
3
1
4
1
FIG 13
15