Bevel Cross Cutting - Genesis GTS10SB Manual Del Operario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Bevel Cross Cutting

warning:
avoid serious personal injury.
1. Remove the rip fence from the table surface.
2. Adjust bevel angle to the desired degree. (0°-45°).
3. Set the blade to the correct depth. Refer to Blade Height Adjustment.
4. Position Miter Gauge to 0°. (Refer to Miter Gauge Adjustment). use the miter gauge in the groove to
the RIGHT of the blade. It can not be used in the groove to the LeFT because the blade guard will
interfere with the cut .
5. Make sure all loose pieces have been removed from the table surface and work piece is not in
contact with blade.
6. Turn ON/OFF switch to the ON position.
7. Position the work piece flat on the table with edge flush against miter gauge fence. Wait until blade
reaches full speed before feeding the work piece into the blade.
8. use two hands to slowly feed the work piece and miter gauge toward the blade. use the hand
furthest from the blade to keep the work piece flush against miter gauge fence and use your other
hand to push the miter gauge and work piece toward the blade. Stand slightly to the side of blade
to reduce the risk of injury should kickback occur.
9. Continue feeding the work piece into the blade until the cut has been completed.
10. Once the cut has been completed, pull the work piece back toward you.
11. Turn the switch off.
12. After blade has stopped completely, remove the cut off piece.
Compound Miter Cross Cutting
warning:
avoid serious personal injury.
1. Remove the rip fence from the table surface.
2. Adjust bevel angle to the desired degree. (0°-45°) (refer to Bevel Adjustment).
3. Set the blade to the correct depth..
4. Position the Miter Gauge to the desired degree. (0°-60°) (Refer to Miter Gauge Adjustment). use the
miter gauge in the groove to the RIGHT of the blade. It can not be used in the groove to the LeFT
because the blade guard will interfere.
5. Make sure all loose pieces have been removed from the table surface and work piece is not in
contact with blade.
6. Turn ON/OFF switch to the ON position.
7. Position the work piece flat on the table with edge flush against miter gauge fence. Wait until blade
reaches full speed before feeding the work piece into the blade.
8. use two hands to slowly feed the work piece and miter gauge toward the blade. use the hand
furthest from the blade to keep the work piece flush against miter gauge fence and use your other
hand to push the miter gauge and work piece toward the blade. Stand slightly to the side of blade
to reduce the risk of injury should kickback occur.
9. Continue feeding the work piece into the blade until the cut has been completed.
10. Once cut has been completed, pull the work piece back toward you.
11. Turn the switch off.
12. After blade has stopped completely, remove the cut off piece.
Non-Through Cutting
Non-through cutting are in cutting grooves, rabbets and dados. This is the only type of cut made with
the blade guard assembly removed. you must make sure the entire blade guard assembly is reinstalled
properly after completion of this type of cut.
20
Make sure the blade guard assembly is properly installed to
Make sure the blade guard assembly is properly installed to
10" Table Saw
Operator's Manual
GTS10SB

Publicidad

Tabla de contenido
loading

Tabla de contenido