Operation - Silvercrest SDB 1500 B2 Instrucciones De Uso

Operation

CAUTION – PROPERTY DAMAGE!
► If you are not sure whether the floor is suitable for cleaning, test an unex-
posed part for compatibility beforehand.
► Always observe the cleaning instructions of the carpet manufacturer. Before
cleaning, check also whether the carpet is suitable for steam cleaning.
► Never use the appliance without a pad
Otherwise the floor could get scratched!
► Never operate the appliance without water in the water tank
The pump could overheat and be damaged!
NOTE
► To achieve the best results, first use the broom and then the steam function.
If you do not want to use the broom function, we recommend vacuuming
the floor first to remove any loose particles of dirt.
Once the appliance is assembled and filled with water:
1) Press and hold in the "Handle" release button
wards so that it clicks into place.
2) If you have not already done so, completely unwind the power cable from
the cable hooks
down the upper cable hook
way and turn it at the same time.
3) Run the cable through the notch
cable does not hang down into the working area.
4) Insert the plug into the mains power socket.
5) Set the On/Off switch
POWER control lamp
6) Use the MODE button
–
Press 1 x: low steam level, green control lamp
–
Press 2 x: high steam level, red control lamp
–
Press 3 x: no steam, standby, POWER control lamp
NOTE
► We recommend the high steam level especially for moisture- and heat-
resistant floor coverings, such as tiles.
► We recommend the low steam level especially for moisture- and heat-
sensitive floor coverings, such as parquet flooring.
SDB 1500 B2
/ . To facilitate the unwinding of the cable, you can flip
. To do this, pull the cable hook
on the rear of the handle so that the
to "I". The On/Off switch
flashes.
to select the desired level of steam generation:
/ on the steam broom
!
and flip the handle up-
lights up, the red
lights up.
lights up.
lights up.
GB │ MT
.
out a little
71 ■
│