Silvercrest SDB 1500 B2 Instrucciones De Uso página 75

7) Wait around 30 seconds while the appliance heats up.
8) Press the "Steam" button
short time, steam is emitted through the underside of the steam broom
9) If required, switch on the broom function by pressing the Start/Stop switch
"Broom"
10) Wipe over the desired area.
NOTE
► Once the water tank
for a short while. The empty water tank
flashing of the control lamps
If the water tank
–
Press the "Steam" button
–
Set the On/Off switch
–
Remove the water tank
scribed in the section "Filling with water".
–
Set the On/Off switch
–
Select the desired steam level as described above and press the "Steam"
button
11) When you are finished treating all of the surfaces, press the "Steam" button
to stop steam production.
12) If you have activated the broom function, deactivate it by pressing the Start/
Stop switch "Broom"
13) Set the On/Off switch
14) Remove the plug from the mains power socket.
NOTE
► If you see streaks on the floor after cleaning with the appliance, this may
be due to the previously used cleaning fluids. Simply clean the floor again
using the steam mop. The smears should now be gone.
GB │ MT
■ 72
│
. The appliance starts generating steam. After a
.
is pumped empty, the pump will continue to run
,
empties during use:
again to stop steam production.
to "O".
, fill it and replace the water tank
to "I".
.
again.
to "O". The POWER control lamp
is indicated by the simultaneous
and .
.
as de-
goes out.
SDB 1500 B2