Icemaker Installation; Unpacking; Important; Location Requirements - Orien FS-50IMOD Manual Del Usuario

Unpacking

Remove packaging materials
IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice
maker.
Remove tape and glue from your ice maker before using.
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue
•
residue can also be easily removed by rubbing a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to
•
remove tape or glue. These products can damage the surface of your ice maker.
Cleaning before use
After you remove all of the packaging materials, clean the inside of your ice maker before using
it. See "Interior cleaning" in the Cleaning and Maintenance section.

Location Requirements

Top View
Rear of uni t
1/5"
Si de
Fr ont of uni t
Ice Maker Installation
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
2/5"
1/5"
Si de
INSTALLATION CLEARANCES
Side View
1"
Top of uni t
8