Assembly Of The Mincer - Unold 78131 Instrucciones De Uso

ASSEMBLY OF THE MINCER

The switch of the mincer must be in the OFF position before the appliance
is connected to the mains!
1. Remove all packaging materials and any transport safety devices. Keep pack-
aging materials away from children - danger of suffocation!
2. Clean all parts with a damp cloth, as described in the chapter "Cleaning and
maintenance".
3. Check if the appliance is switch off.
4. Place the motor block on a solid and flat surface. The switch has to be on
the front side. Do not cover the ventilation openings in the bottom.
5. Insert the feeding worm into the worm housing. The tooth wheel at the end
of the feeding worm should be greased after each cleaning with a greasing
agent admitted for contact with foodstuff.
6. Place the cross bladed knife on the axle of the worm. The flat side of the
knife must faces the outside (mincing plate), the rounded side the inside
(feeding worm). If not correctly installed, the meat cannot be minced prop-
erly.
7. Place the required mincing plate onto the knife. The small arresting tab at
the inner side of the worm housing must fit exactly into the little recess of
the mincing plate.
8. Firmly screw on the closing ring while holding the mincing plate in place.
Do not overtighten.
9. Place the mincer head in the opening of the motor block. The feeding tube
faces the user. Press the locking button down and fix the mincer head, until
the feeding tube is vertical. Then release the locking button.
10. Press the feed pan firmly onto the feeding tube.
11. Connect the appliance to the mains.
12. The mincer is now ready for use.
Important advice!
The appliance disposes of an electronic control with time delay, so the mo-
tor will start only a few seconds after switching on.
Stand 10.3.2020
Copyright UNOLD AG | www.unold.de
DE
EN
FR
NL
IT
ES
PL
27 von 80