General Safety Instructions; Maintenance And Storage - Virax Siberia Manual De Instrucciones

Safety instructions
Translation from the original manual.
Read and retain these instruction for use.
In order to reduce the risk of electric shock, injuries and fire when using electric tools, observe the
following basic safety measures.

General safety instructions

Safety instructions relative to electrical equipment

Check the voltage indicated on the plate.
Choice of tool

Remove the plug from the socket.

Preserve the supply cable. Do not carry the tool by the cable, do not pull on the cable in order to
remove the plug from the socket.

Keep the cable away from heat, oil and sharp edges.

Avoid any involuntary start up. Do not carry the tool while having a finger on the switch when it is
connected to the mains.

When outside, only use approved extension cables with the corresponding marking.

Maintenance and storage


Store your tools in a safe place. Unused tools must be stored in a dry and locked place, out of the
reach of children.

Regularly check the state of the plug and the supply cable and in the event of damage, have them
changed by a qualified technician. Periodically check the extension cable and replace it if it is
damaged. Keep the handles dry and free of oil and grease.

Check whether your tool is damaged. Before using the tool, always carefully check the perfect
functioning of its parts. Check if the operation of the moving parts is correct, if they seize up or if
other parts are damaged. All the components must be correctly assembled to meet the conditions
required to guarantee the impeccable functioning of the tool. Any safety device, any switch or any
other part which is damaged or defective must be repaired or replaced in an appropriate manner
by a qualified technician. Do not use any tool on which the switch does not correctly open or close
the circuit.

Caution! Ensure that you use the tool and its accessories in accordance with the safety
instructions. Also take account of the tool's possibilities by paying attention to the working
conditions and the task to be undertaken. Using the tool for tasks other than those intended may
be dangerous.

This tool satisfies safety rules in force. All repairs must be undertaken by qualified professionals
with original spare parts; if not, the tool may pose a danger for the user and invalidate the
guarantee.

Store the hoses, the refrigerating clamps and the freezer heads inside the Siberia®.

Store only in vertical position in a dry and dust-free place at a temperature between -10°C and
35°C.

Protect against impacts and vibrations.
14
EN