Dmx-Protocol - Futurelight PFE-1200 Manual Del Usuario

This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
2. If the lamp is on, the the display will show "A00.1" with the actually set address. If the lamp is off, the the
display will show "A001" with the actually set address.

DMX-protocol

Control channel 1 - Colour-wheel
Linear colour change following the movement of the slider. In this way you can stop the colour-wheel in any
position.
Decimal Hexad. Percentage S/F
0 10 00 0A 0% 4%
11 21 0B 15 4% 8%
22 32 16 20 9% 13%
33 43 21 2B 13% 17%
44 54 2C 36 17% 21%
55 65 37 41 22% 25%
66 76 42 4C 26% 30%
77 87 4D 57 30% 34%
88 98 58 62 35% 38%
99 127 63 7F 39% 50%
128 187 80 BB 50% 73%
188 193 BC C1 74% 76%
194 255 C2 FF 76% 100%
Control channel 2 - Static gobo-wheel, gobo shake
Decimal Hexad. Percentage S/F
0 14 00 0E 0% 5%
15 29 0F 1D 6% 11%
30 44 1E 2C 12% 17%
45 59 2D 3B 18% 23%
60 74 3C 4A 24% 29%
75 89 4B 59 29% 35%
90 113 5A 71 35% 44%
114 137 72 89 45% 54%
138 161 8A A1 54% 63%
162 185 A2 B9 64% 73%
186 209 BA D1 73% 82%
210 255 D2 FF 82% 100%
S Open / white
S Col 1
S Col 2
S Blue
S Yellow Green
S Light Yellow
S Magenta
S Orange
S Purple
S Color shake
F Forwards rainbow effect with decreasing speed
S No rotation
F Backwards rainbow effect with increasing speed
S Open
S Gobo 1
S Gobo 2
S Gobo 3
S Gobo 4
S Gobo 5
F Gobo 1 shake with increasing speed
F Gobo 2 shake with increasing speed
F Gobo 3 shake with increasing speed
F Gobo 4 shake with increasing speed
F Gobo 5 shake with increasing speed
F Cont. gobo-wheel rotation with increasing speed
36/93
Feature
Feature
51837580_V_1_2.DOC