Technical Specifications; Disposal Of Old Electrical Appliances - cecotec CONGA 1690 Manual De Instrucciones

ENGLISH
The robot does not work properly.
The robot emits a strange noise during
cleaning.
The robot does not clean efficiently or
dust leaks from the robot.
The robot could not connect to Wi-Fi.
The robot did not carry out the scheduled
cleaning task.
40
Turn the robot off, switch it off and turn it on
again.
With the robot turned on and having left the
charging base with the dust tank installed,
hold down the scrubbing button on the
robot for 5 seconds. Then, immediately stop
pressing it and press the Back home button
until the robot beeps. This way the robot will
be restarted.
The main brush, side brush or omnidirectional
wheel may have foreign matters tangled, stop
the robot and clear it up.
The dust tank is full. Empty it and clear the
high-efficiency filter if it is blocked.
The high-efficiency filter is blocked, clear it.
The main brush is tangled with foreign matter,
please clear it up.
The Wi-Fi signal is poor. Make sure the Wi-Fi
signal is correct.
The Wi-Fi connection is unstable. Reset the
router, check if there are any App updates and
try again.
Make sure your device's mobile data are
deactivated to improve the binding process.
Check if the robot is in Night mode and switch
mode. The robot does not carry out scheduled
cleaning cycles under this mode.
Make sure the robot is connected to the
network, it will not be able to carry out
scheduled cleaning tasks without being
connected.
The robot does not return to the charging
base after spot cleaning or after changing
starting position.
The robot does not resume cleaning.
The robot is always offline.
Connection between the mobile phone
and the robot failed.

10. TECHNICAL SPECIFICATIONS

Model: Conga 1690 Pro
Product reference: 05421
100-240 V~ 50/60 Hz
Battery: 14,8 V, 3200 mAh
Frequency bands: 2.412-2.472 GHz
Maximum Transmission Power: 16 dBm
Made in China | Designed in Spain

11. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), specifies that old household electrical appliances must
not be disposed of with the normal unsorted municipal waste. Old appliances
ENGLISH
The robot will map and calculate a new route
after operating under spot cleaning or after
having changed its starting position.
If the charging base is very far away from
the robot, it will not be able to charge back
automatically. Put the robot back on the
charging base manually.
Make sure the robot is not in Sleep mode, it
will not resume cleaning under this mode.
It won't resume cleaning when it is placed
manually on the charging base.
Make sure the robot is successfully connected
to the network and always in the range
covered by the Wi-Fi signal.
Make sure the robot and the charging base
are in an area with good Wi-Fi signal, reset
the router and try connecting them again.
41