Aligning The Wall Plate - GE CVM521P2MS1 Instrucciones De Instalación

ALIGNING THE WALL PLATE

D.
Wear gloves to avoid cutting fingers
CAUTION
on sharp edges.
1 Draw a vertical line on the wall at the center of the
30 wide space.
2
sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for
cabinets with front overhang. Line up the notch
and centerline on the bottom of the mounting plate
to the centerline on the wall.
3 While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C and D
(see illustration above/actual plate marked with
Four holes must be used for mounting.
10
Installation Instructions
Centerline
Area E
as the template for the rear
Draw a
on Wall from
Cabinet
NOTE:
C nor D is in a stud, find a stud somewhere in area
E and draw a fifth circle to line up with the stud. It is
important to use at least one wood screw mounted
firmly in a stud to support the weight of the
microwave.
Set the mounting plate aside.
WARNING
Risk of electric shock. Can cause
injury or death. Take care to not
drill into electrical wiring inside walls or cabinets.
4
Drill holes on the circles. If there is a stud, drill a
hole for wood screws. For holes that don't line up
with a stud, drill a
5 8
holes for toggle screws.
5 8
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
hole for toggle bolts. Drill two
3 16