Replacing The Light Bulbs - GE Profile JVM1790 Serie Manual Del Propietário

Replacing the light bulb.
Remove screw.
CleanSteel
Use a clean, soft, light and lightly dampened cloth, then dry thoroughly. Do not use
appliance wax, polish, bleach or products containing any chemical agent on the CleanSteel
surfaces.
Plastic Color Panels
Use a clean, soft, lightly dampened cloth, then dry thoroughly.
Door Seal
It's important to keep the area clean where the door seals against the microwave. Use only
mild, non-abrasive detergents applied with a clean sponge or soft cloth. Rinse well.
Bottom
Clean off the grease and dust on the bottom often. Use a solution of warm water and
detergent.
Cooktop Light/Nite Light
Replace with a 120 volt, 40 watt (max.) halogen
bulb. Order WB08X10051 from your GE supplier.
1 To replace the cooktop light/nite light,
first disconnect the power at the main
fuse or circuit breaker panel, or pull
the plug.
2 Remove the screw from the side of the
light compartment cover and lower the
cover until it stops.
3 Be sure the bulb is cool before
removing. Break the adhesive seal
by gently unscrewing the bulb.
Screw in the new bulb, then raise the
4
light cover and replace the screw.
Connect electrical power to the oven.
ge.com
27