Garland BLV 2500 CLV Instrucciones De Manejo página 17

Electric vacuum / blower
Technical Specifications
Rated voltage
Rated frequency
Rated power consumption
Fuse (time lag)
Rotation
Max. blowing speed
High blow volume
Bag volume
Weight (without flex)
Protection class II/VDE 0700
The A-rated sound pressure level of the device measured in accordance with DIN 45635 Part1, Appendix D is:
Weighted sound pressure:
Vibration max.
These values were measured in accordance with the following standards: EN 60 335-1/A1:2004; EN 60 335-2-
100:2002
This device has a radio interference suppression according to: EN 55014-1, EN55014-2
Please wear ear protectors!
Operating range
This Blower/Vacuum device must only be used to
blow away or vacuum dry and light materials as e.g.
dry leaves, small branches, and pieces of paper. The
vacuuming of heavy materials as e.g. metal, stones, big
branches and broken glass is expressively excluded.
Assembly
Suction tube fitting (fig.1-8)
- Put together the two suction pipes and connect them
with the two screws (X) Fig 1-2
- Insert after the complete vacuum tube into the motor
housing until the stop and secure it with screws (X) on
the motor housing (Fig. 3-8).
Never operate the tool without the pipe completely
assembled and fixed by screws.
Air blow pipe fitting (fig.9-11)
- Unscrew the 3 parts of the blowpipes together, as
shown in Figure 9 and 10 shown.
- Then connect the blowpipe complete with the motor
housing (Fig. 11)
BLV 2500 CLV
V~ 230
Hz 50
W 2500
A 16
rpm 8.000-13.000
m/s 160-270
m / min. 14
3
l 50
kg 4,3
88,3 dB(A) [K 3,0 dB(A)]
2
4,0 m/s² [K 1,5 m/s
GB-3
]
Dust collection bag (10) with handle (8) fitting
(Fig.12-15)
- Connect the Fangsack, with the handle bracket and
make sure that those in the right direction as in Figure
13 shows.
- Press the A button, and put the Fangsack to mount on
the motor housing (Fig. 14 and 15)
Shoulder strap (fig.16-18)
Loop the shoulder strap on the chassis mount and screw
threaded sleeve. Adjust the strap to the desired length.
OPERATION
Before the startup
Before the startup of the tool, you ensure that the tubes
and collecting bag is installed and well fixed correctly.
Adjust shoulder strap to the height of good work.
Switch ON/OFF
Press the ON/OFF switch (7) to turn on the tools, release
the ON/OFF switch the tool will turn off automatically.
When you do not work, turn off the tool and remove the
plug from socket-outlet.