Cleaning And Maintenance - Grunkel CAR-G20 Manual De Instrucciones

Insert power plug into a wall socket with correct power output,
220-240V 50Hz.
•
Turn ON/OFF control switch to either:
•
- " " for Fan Only
- "I" for Low Heat
- "II" for High Heat
NOTE: When the heater is switched ON, the red power indicator light will turn ON (make sure
to turn the temperature control setting pass the midpoint, selecting a lower setting will not turn
the heater ON).
• Turn the temperature control setting clockwise to increase temperature and
anti-clockwise to decrease temperature. The heater will turn ON and OFF to maintain the
desired heat setting.
NOTE: The heater may emit small amount of smoke and odour when used for the
first time. This is normal and caused by the lubricant on the heating element during
the production process. It is non-toxic. If the smoke and odour are excessive, use the
heater in a ventilated area. The smoke and odour should disappear after a few
minutes of use.

CLEANING AND MAINTENANCE

Before cleaning
-When not in use or before cleaning, always disconnect the appliance from the main
power supply.
Cleaning
-Cleaning can only be done when the unit is cooled. Do not immerse the whole unit in
water. Do not use harsh solvents on this unit.
- Wipe the exterior of the appliance with a damp cloth. Dry the unit completely with a dry
towel
Damage check
-Always check that the appliance is not damaged, is in good working order and that all parts
are secure. Check the power supply cord and plug regularly for cuts or damage. For safety
purposes, DO NOT use the heater if damage is found.
Store in a safe place
-When not in use, store your appliance and instruction manual in a safe and dry place.
NOTE: Always clean and store away your appliance with this instruction manual when not use.
14