Complete Installation - Sears Kenmore Elite 66495223710 Instrucciones De Instalación

4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away
from the oven doorframe.
To Replace:
1. Insert both hanger arms into the door. Be sure that the hinge
notches are engaged in the oven doorframe.
A
A. Hinge notch
2. Open the oven door.
The door should be able to open all the way.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close and is level while
closed. If it is not, repeat the removal and installation
procedures.
14

Complete Installation

1. Check that all parts are now installed. If there is an
extra part, go back through the steps to see which step
was skipped.
2. Check that you have all of your tools.
3. Check that you have all of the range accessories,
especially oven racks. These accessories may be
in the range packaging.
4. Dispose of/recycle all packaging materials.
5. Check that the range is level. See the "Level Range" section.
6. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth. For more information, see
the "Range Care" section of the Use & Care Guide.
7. Read the Use & Care Guide.
8. Plug power cord into a grounded outlet. Turn power on.
9. Turn on surface elements and oven. See the Use & Care
Guide for specific instructions on range operation.
NOTE: Odors and smoke are normal when the oven is used
the first few times.
If Range Does Not Operate, Check the Following:
Household fuse is intact and tight or circuit breaker has
■
not tripped.
Range is plugged into a grounded outlet.
■
Electrical supply is connected.
■
IMPORTANT: If the range control displays an "F9" or
"F9, E0" error code, the electrical outlet in the home may
be miswired. Disconnect power and contact a qualified
electrician to verify the electrical supply.
10. When the range has been on for 5 minutes, check for
heat. If the range is cold, turn off the range and contact
a qualified electrician.
If You Need Assistance or Service:
Please reference the back cover of the Use & Care Guide
to contact service.