Brita On Tap Instrucciones De Uso página 7

The BRITA On Tap filter system is not intended to be
connected to a low-pressure water heater; it is an
external contact system and its internal receptacle will
not support the pressure of the supply pipe.
The following characteristics will help you determine
whether your equipment is a low-pressure water heater:
• A low-pressure water heater is usually installed
immediately next to the sink or underneath it.
• Low-pressure taps are fitted with 3 connections
(open system).
• When the supply of hot water has been used
(between 5 and 10 litres), only cold water will come
out of the tap.
The BRITA On Tap water filter system can be easily
connected to the following hot water supplies:
Please note that hot water may only be used with the
BRITA On Tap's unfiltered water settings (shower and
stream) and only cold water may be filtered.
As a general rule, the central supply of hot water in a
house is connected to the central heating system. This
is usually located in the cellar, loft or in a cupboard.
Instant water heaters (pressurised systems) are installed
in pressurised pipes and must be able to withstand the
pressure applied. This type of water heater often supplies
hot water to several parts of the house (e.g. the kitchen
and bathroom). In contrast to the traditional system, the
instant water heater supplies hot water within a few
seconds and in an unlimited quantity.
Large volume water heaters (> 50 litres) operate under
pressure. In most cases, these water heaters supply
hot water to several parts of the house (e.g. the
kitchen and bathroom).
Filter cartridge life: approx. 600L
Working pressure: 0.7 bar to 3.5 bar
Working temperature: 4°C to 30°C (filtered water)
Nominal flow:
1.6L/ minute (according to JIS S 3201:2004)
For over 50 years, BRITA has stood for constant
innovation and the highest quality in the development
of water filter solutions. To justify high quality
requirements at BRITA there are stringent internal and
external quality controls.
BRITA is convinced that this BRITA product will satisfy
your demands of quality and performance. If you are
not completely satisfied with your BRITA product,
BRITA guarantees to give you your money back within
30 days from the date of purchase. Please call your
local customer service team before sending in your
BRITA On Tap. Every BRITA On Tap water filter
system is warranted to be free from defects in material
and workmanship at the time of delivery. Any warranty
claims will be voided if defective installation is deemed
to have contributed to malfunction. Installation needs
to take place in accordance with the instructions and
all relevant plumbing codes and standards. Our goods
come with guarantees that cannot be excluded under
the Australian and New Zealand Consumer Law. You
are entitled to a replacement or refund for a major
failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not
amount to a major failure. In the event of a warranty
claim, for Australia and New Zealand, please contact
BRITA Water Filter System Distributors Pty Ltd, Level
9, 123 Epping Rd, North Ryde, NSW 2113, Australia.
Email: solutions@brita.com.au,
Phone: AUS: 1300 557 762, NZ: 08004 BRITA
Do you have any questions about your BRITA product,
or on the subject of water filtration? Just give us a call!
You can find the contact details for your BRITA
customer service next to your country code on page
47 of this manual.
Are you looking for your nearest BRITA stockist? Do
you want more detailed information about BRITA
products, or about the BRITA Company? Do you want
to benefit from our many services and offers?
Up-to-date information can be found at: www.brita.net
6