Toshiba TEC B-480-QP Serie Manual De Instrucciones página 16

5. LOADING THE MEDIA
Removing the paper holders' upper plates from the media guide
1 Remove the two T-4x8 screws to detach the media guide from the printer.
2 Remove the SM-3x6 screw or the SM-3x8 screw to detach the paper holders' upper plates from
the media guide.
Paper Holder
3 Attach the media guide back in position.
NOTE: Do not lose the removed upper plates because they are required when using the label rolled
with labels facing inside.
9. Set the black mark/feed gap sensor to the correct position by turning the adjusting knob. Turning the
knob right will move the sensor towards the center of the media while turning left will move it away from
the center of the media.
(Right)
Screw (SM-3x6)
Screw (SM-3x8)
Paper Holder
E5-3
ENGLISH VERSION EO1-33007
5. LOADING THE MEDIA
Media Guide
Screw (T-4x8)
Fig. 5-5
(Left)
Fig. 5-6