Threshold Setting - Toshiba TEC B-480-QP Serie Manual De Instrucciones

9. GENERAL MAINTENANCE

9.4 Threshold Setting

For the printer to maintain a constant print position it uses the feed gap sensor to detect the gap between
labels by measuring the amount of light passing through the media. When the media is pre-printed, the
darker (or more dense) inks can interfere with this process causing paper jammed errors. To get around
this problem a minimum threshold can be set for the sensor in the following way.
Threshold setting procedure
O N L I N E
P A U S E
T R A N S M I S
R E F L E C T I
T R A N S M I S
T R A N S M I S
P A U S E
O N L I N E
O N L I N E
< Supplementary Explanation >
(1) When the [PAUSE] key is released within 3 seconds while printer pauses, the [PAUSE] key is invalid.
(2) When the threshold is programmed, 1.5 sheets of the label should be fed. (If less than 1.5 labels are
fed, the threshold may not be properly programmed. In this case, reprogramming is required.)
(3) When the [PAUSE] key is pressed for 3 seconds or more in a head-up state, the [PAUSE] key is invalid.
(4) During a label feed, an error including the paper end, ribbon end or cutter error is not detected.
Power on
[PAUSE] key.
[PAUSE] key.
S I V E
[FEED] key.
V E
[FEED] key.
S I V
E
[PAUSE] key.
S I V
E
[RESTART] key.
Command
(1) Online
(2) Load the preprinted label. (No particular positioning is required.)
(3) Press the [PAUSE] key.
(4) The printer is in the pause state.
(5) Press the [PAUSE] key for 3 seconds or more while the printer
is paused.
(6) The sensor selection to set the threshold manually is displayed.
The transmissive sensor designation is displayed.
(7) Press the [FEED] key.
(8) The reflective sensor designation is displayed.
(9) Press the [FEED] key.
(10) The transmissive sensor designation is displayed.
(11) Press and hold the [PAUSE] key.
(12) The printer feeds labels until the [PAUSE] key is released.
(13) The [PAUSE] key should be held until more than 1.5 sheets
of the label are fed. When the [PAUSE] key is released, the
printer stops feeding the label. (Threshold setting for the
selected sensor is completed.)
(14) Press the [RESTART] key.
(15) Online
(16) The label is printed according to the command issued from the
PC.
E9-4
ENGLISH VERSION EO1-33007
9.4 Threshold Setting