Using The Dehumidifier; Water Drainage; Air Filter - Woods MRD10 Manual De Instrucciones

PLACEMENT OF DEHUMIDIFIER
- The dehumidifier should not be placed
near radiators or other heat sources or
exposed to direct sunlight, as it will reduce
performance.
- Ideal is to put it in the centre
of the room / area.
NOTE: When placed in a
shower room or bathing area, the
dehumidifier should be fixed in place. It
is compulsory to check and respect your
local bathroom electrical regulations
before use.

USING THE DEHUMIDIFIER

If the dehumidifier is transported
horizontally, let the dehumidifier stand
for a 4 hours before being used. It is very
important that the oil runs back into the
compressor, otherwise the dehumidifier
may be seriously damaged.
1. Check that the water reservoir is correctly
placed.
2. Connect the dehumidifier to an grounded
power source.
3. Set the desired humidity level by means of
the humidity control. See the section on the
humidity control.
NOTE: The ambient relative humidity
can be simply measured with the
dehumidifier.
OPERATION MANUAL
1. Power Button: This button can control
the machine on and off.
2. Humidity button: To set the desired
humidity
3. Humidity Settings: Open the air
outlet set humidity between 40%,
50%, 60% or continuous mode.
4. Timer: When the appliance is on,
press the Timer 2H/4H/6H to operate
a countdown.

WATER DRAINAGE

When the water reservoir is full, the
dehumidifier is shut off automatically.
Once the water reservoir is emptied the
unit will automatically restart.
1. Disconnect the dehumidifier from the
power source.
2. Empty the water reservoir.
3. Put the empty water reservoir back
and check that the float moves freely.
4. Connect the dehumidifier to the
power source.
Direct water drainage
Connect a water hose to the pipe on the
back of the dehumidifier. Lead the other
end to a drain. Make sure that the water
can be drained downwards.

AIR FILTER

The air filter prevents dust and dirt from
entering the machine, prolonging its life
expectancy. It
is important the filter is cleaned regularly.
Filter cleaning:
1. Remove the filter.
2. Wash it with warm water and a mild
cleansing agent. Alternatively the
filter may be vacuum cleaned.
3. Let the filter dry and put it back.
DEFROSTING OPERATION
During the defrosting operation, the
dehumidification function may intermit.
Please don't turn off the switch or pull out the
power plug of the dehumidifier during the
defrosting operation. This dehumidifier can't be
applicable to keep extreme low temperature.
The purpose of this dehumidifier is to pump off
the unpleasant high humidity in daily life and
dry the wet things. But it can't be used to keep
extreme low temperature.
Operating Instructions
The room temperature increases during the
operation.
This dehumidifier doesn't have colling function.
It will produce heat during the operation and
increase the room temperature to 1 to 4°C. In
addition, the door and windows are closed
and other appliances in the room can give out
heat as well as the radiation of the sun can
raise the room temperature.
GB
11