Urrea UD85 Manual De Usuario Y Garantía página 32

E N G L I S H
Recording mode.
To exit this mode and erase recorded
readings, hold the REC button down for 2
seconds.
Press the arrow (
blinking number position to the left by
1 decimal point when the Meter is in the
Editing mode. When the blinking number is
at the very left, the number will stay at the
same position even if you press the arrow (
) button.
9 – (Relative Readings in the
Relative mode; A Right-shift button
when the Meter is in the Editing
mode.).
In the Relative mode, this Meter displays the
difference between the stored reference
value and the measured reading value.
Press the REL button to enter the Relative
mode. The "REL" symbol will come on the
LCD and the bar graph pointer will be at the
center of the scale.
Press the EDIT button to program the
reference value. Using the arrow ( , ,
and ) buttons, enter the value that you
want the readings displayed in relation to.
Once the value is entered, press the EDIT
button to exit the Editing mode.
To recall the store value, press the HI/LO
(RANGE) button.
All measurement will be displayed as the
difference between the stored value and
the measured value. Negative readings
are lower than the stored value. Positive
readings are higher than the stored value.
Pushing the REL button again exists the
model.
Press the arrow (
blinking number position to the left by
1 decimal point when the Meter is in the
Editing mode. When the blinking number is
32
) button to shift the
) button to shift the
at the very right, the number will stay at the
same position even if you press the arrow (
) button.
10. (% Reading in the
Percentage mode;
button when the Meter is in the
Editing mode).
In the Percentage mode, this Meter displays
the difference in percentage between the
stored reference value and the measured
value.
Press the % button. The "%" symbol will
come on the LCD and the bar graph pointer
will be at the zero on the scale. The recall
the stored reference value, press the HI/LO
(RANGE) button.
Press the EDIT button. Using the arrow
buttons, enter the value you want the
readings displayed as a percentage of. Once
the value is entered, press the EDIT button
to exit the mode.
All measurement will be displayed as the
difference in percentage between the
stored reference value and the measured
value. Negative readings are lower than the
stored value. Positive readings are higher
than the stored value. Pushing the % button
again exits the mode.
Press the arrow (
blinking number displayed on the LCD by 1
digit when the Meter is in Editing mode.
11 – (Toggles between DC
and AC; Toggles between °C and °F in
the Temperature mode).
Press the DC/AC button to toggle between
DC and AC when measuring volts (except
) or amperes. When AC is selected, the "AC"
symbol is displayed.
A Decrement
) button to decrease the