Descargar Imprimir esta página

HQ-Power VDLPROM12 Manual Del Usuario página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Replace any deformed or damaged lamp with a lamp of the same type (see "7. Technical
Specifications"):
1.
Unscrew the front ring, holding the lamp into place.
2.
Remove the old lamp and unscrew the wires from it.
3.
Fasten the wires to the new lamp, put it in the housing and fix it by fastening the fixation ring.
Colour Wheel
1.
Carefully unpack the colour wheel and remove the protective film.
2.
Fix the colour wheel to the axe of the motor by means of the screw provided.
The Pin Spot
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
The construction to which the pin spot is attached should be able to support 10 times the weight of
the device for one hour without deformation.
The installation must always be secured with a secondary attachment e.g. a safety cable.
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
Overhead mounting requires extensive experience: calculating work load limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
Make sure there is no flammable material within a 50 cm radius of the device.
Have a qualified electrician carry out the electric connection.
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
The installation has to be approved by an expert before the device is taken into service.
The Mirror Ball and Motor
The construction to which the mirror ball is attached should be able to support 10 times the weight of
the device for one hour without deformation. It should be able to hold a minimum of 10kg point load.
The installation must always be secured with a secondary attachment e.g. a safety net.
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
Overhead mounting requires extensive experience: calculating work load limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
The mirror ball has to be connected to the motor via the chain. Make sure the motor is installed
perfectly horizontally. There are 3 holes in the base plate for fixation screws.
Make sure the rotation of the mirror ball is never hampered and that no side forces can impact on the
installation.
The installation has to be approved by an expert before the device is taken into service.
Stroboscope
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
The installation must always be secured with a secondary attachment e.g. a safety cable.
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
V. 01 – 08/12/2014
VDLPROM12
5
©Velleman nv

Publicidad

loading