Usage Steps - Ducati DPW 2100 Manual De Usuario

ponents MUST be carried out by qualified
staff. ACCIDENT HAZARD.
8. Shut down the appliance, cut power supply
and water supply. Then, discharge the
residual pressure by triggering the gun
before disconnecting the unit hose. INJURY
HAZARD
9. Before using the appliance, CHECK every
time that the screws are fully tightened and
that there are no broken or worn parts.
ACCIDENT HAZARD.
10. ONLY USE detergents which will not corro-
de the coating materials of the high pressu-
re hose/electrical cable. EXPLOSION AND
ELECTRIC SHOCK HAZARD.
11. ENSURE that all persons or animals keep
a minimum distance of 16yd. (15M)away.
INJURY HAZARD.
12. The unit should STAND when it's working.
13. This appliance can NOT be stored in a
damp environment.
14. When stopping the appliance, shut off the
appliance's switch before pulling plug out.
15. Use only original or manufacturer approved
spare parts for safety reasons.
16. Total Stop (motor stops when trigger
released) does NOT always keep effective
and the appliance can NOT be at Total Stop
for long time. If ineffective (for inner seal
damaged, local voltage too low etc), MUST
turn off the switch to stop the machine
during working.
Safety "must knows"
CAUTION - DANGER!:
1. Do not tamper with or adjust the safety
valve setting.
Safety valve and/or pressure limiting valve.
Owner´s manual
The safety valve is also a pressure limiting valve.
When the gun trigger is released, the valve opens
and the water. Recirculates through the pump inlet
or is discharged onto the ground.
2. Safety catch (see Connection of gun and
hose)
Prevent accidental spraying of water.
3. Air outlet on plastic case and it should
NOT be blocked during operation, or fire or
electric shock hazard is possible.

3. USAGE STEPS

1. Stand the machine up, place it on a flat
ground.
2. Check the water entry filter to make sure it
is free of blockage.
3. Use detergent for better wash.
4. Connect the lance onto the gun handle.
(appliance stops)
5. Connect the gun with the high pressure
hose on the winding roll.
6. Pull the high pressure hose out of the
winding roll.
7. Connect the hose onto the water output
exit.
8. Connect the water supply hose to the
water entry of the machine.
9. Connect another end of the supply hose to
water source.
10. Press the gun trigger and turn on the
water tap to expel the air inside the
machine.
11. Plug in and turn on the machine.
12. Turn the nozzle until the water stream is
in a shape you want. See pic 1 and pic 2
English
29